Rear Object Sensor Replacement

Fig 1: Rear Object Sensor

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedures: Remove rear fascia. Refer to REAR BUMPER FASCIA REPLACEMENT .
1	Rear Object Sensor Tip: Do not refinish previously painted sensors. Press tab to release the sensor from the retainer. Disconnect the electrical connector. Paint the new rear object sensor. Refer to BASECOAT/CLEARCOAT PAINT SYSTEMS . Using a paint thickness gage suitable for non-ferrous metals, ensure paint thickness does not exceed 6 mils. Refer to PAINT GAGES .
2	Rear Object Retainer
3	Rear Object Retainer