LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Buick >> 2009 >> Allure Super >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System & Fuel System - 5.3L - DTC P0016 To DTC P0358 >> DTC P0102 or P0103 >> Circuit/System Testing
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Circuit/System Testing

IMPORTANT: All electrical components and accessories must be turned OFF and allowed to power down.
  1. Ignition OFF, disconnect the MAF/IAT harness connector at the MAF/IAT sensor.
  2. Ignition OFF, test for less than 5 ohms between the ground circuit terminal C and ground.
    • If greater than the specified range, test the ground circuit for an open/high resistance.
  3. Ignition ON, verify that a test lamp illuminates between the ignition circuit terminal B and ground.
    • If the test lamp does not illuminate, test the ignition circuit for a short to ground or an open/high resistance.
  4. Ignition ON, test for 4.8-5.2 volts between the signal circuit terminal A and ground.
    • If less than the specified range, test the signal circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the ECM.
    • If greater than the specified range, test the signal circuit for a short to voltage. If the circuit tests normal, replace the ECM.
  5. Connect the J 38522  to the vehicle. Refer to Component Testing below for instructions.
scientia non olet · About LEMON Manuals