LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Buick >> 2012 >> Regal Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 214 (Power Steering System) >> Repair Instructions >> Steering Gear Boot Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2011 Buick Regal. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Steering Gear Boot & Clamp
    GM1857581Courtesy of GENERAL MOTORS CORP.
  1. Install the steering gear boot (3) to the steering linkage inner tie rod.
  2. Install the new steering gear boot clamp (2) onto the steering gear boot (3).
  3. Install the steering gear boot to the steering gear (1). Ensure the steering gear boot is seated in the assembly groove of the steering gear.
  4. Use the J-35566:  pliers in order to crimp the steering gear boot clamp.
    5. Fig 2: Steering Gear Boot Clamp & Steering Linkage Inner Tie Rod Nut
    GM1857580Courtesy of GENERAL MOTORS CORP.
  5. Install the steering gear boot clamp (1).
  6. Install the steering linkage inner tie rod nut (2).
  7. If equipped, install the steering gear heat shield.
  8. Install the steering linkage outer tie rod. Refer to Steering Linkage Outer Tie Rod Replacement .
scientia non olet · About LEMON Manuals