Installation Procedure
WARNING: This page is about a different variant/trim than selected.
- Install the generator control and battery module (2) in through the trunk opening.
- Slide the generator control and battery module into position and install the vent tube (1) into the floor.
- Remove the EL-48264 Battery Pack Lifting Adapter.
- Install the generator control and battery module into position and tighten the mounting bolts (1) to 22 N.m (16 lb ft).
- Install the body harness connectors (1).
- Install the drive motor battery cooling air inlet lower duct retainers (1).
- Install the intermediate duct retainers (1) to the generator control and battery module.
- Install the drive motor battery cooling blower. Refer to Drive Motor Generator Battery Bracket Replacement .
- Install the high voltage 3-phase cable (2) to the generator control and battery module. Tighten the nuts (1) to 9 N.m (80 lb in).
- Install the 12V cable (3) to the generator control and battery module. Tighten the nut (4) to 9 N.m (80 lb in).
- Install the rear compartment floor panel. Refer to Rear Compartment Floor Panel Trim Replacement (with Battery Cover, HP6) , Rear Compartment Floor Panel Trim Replacement (with Blower Cover, HP6) .
- Install the rear end trim finish panel. Refer to Rear End Trim Finish Panel Replacement .
- Remove the rear end trim finish panel. Refer to Rear End Trim Finish Panel Replacement .
- Enable the high voltage battery. Refer to High Voltage Enabling .
- Program the generator control module, if replaced. Refer to Control Module References .
- Program the battery energy control module, if replaced. Refer to Battery Energy Control Module Programming and Setup .
CAUTION:
Refer to Fastener Caution .
NOTE:
Make sure the duct is flush against the seal for efficient generator control and battery module cooling.
NOTE:
Make sure the duct is flush against the seal for efficient generator control and battery module cooling.