Electronic Brake Control Module: Testing and Inspection

Electronic Brake Control Module Programming and Setup

The following service procedures require either a programming or a setup event performed for a complete repair.

Electronic Brake Control Module Replacement

If the electronic brake control module (EBCM) needs to be replaced, the following procedures must be performed:

1. Connect a scan tool to the vehicle and access SPS. Refer to Service Programming System (SPS) Service Programming System (SPS).

2. Perform the SPS function Electronic Brake Control Module-Programming and follow the on-screen instructions.

3. Perform the SPS function Electronic Brake Control Module-Setup and follow the on-screen instructions. Setup and follow the on-screen instructions.

4. Clear DTCs after completing the programming procedure.

Electronic Brake Control Module Reprogramming

If the EBCM needs to be reprogrammed, the following procedures must be performed:

1. Connect a scan tool to the vehicle and access SPS. Refer to Service Programming System (SPS) Service Programming System (SPS).

2. Perform the SPS function Electronic Brake Control Module-Programming and follow the on-screen instructions.

3. Clear DTCs after completing the programming procedure.