Circuit/System Verification
WARNING: This page is about a different car, the 2015 Cadillac SRX. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition ON.
- Verify that B390A 08 or B390A 45 is not set.
- If either DTC is set
- Program the appropriate B233 Radar Sensor Module - Short Range.
- Verify the DTC does not set.
- If the DTC sets, replace the appropriate B233 Radar Sensor Module - Short Range.
- If the DTC does not set
- All OK.
- If DTC is not set
- Verify that B390A 54 is not set.
- If DTC is set
Replace the appropriate B233 Radar Sensor Module - Short Range.
- If the DTC is not set
- If DTC is set
- Verify that B390A 58 is not set.
- If DTC is set
- Verify the area in front of the sensor is clean, unobstructed, and damage-free.
- If not clean, unobstructed, and damage-free, clean or repair as necessary.NOTE:
After correcting the problem, it may be necessary to drive the vehicle to clear the DTC. Refer to Diagnostic Aids.
- If clean, unobstructed, and damage-free, replace the appropriate B233 Radar Sensor Module - Short Range.
- If not clean, unobstructed, and damage-free, clean or repair as necessary.
- If DTC is not set
- Verify that B390A 67 is not set.
- If DTC is set in both modules
- Verify modules have not been swapped side to side.
- If modules have been swapped, swap them back.
- if modules have not been swapped or DTC persists, refer to Circuit/System Testing.
- If DTC is set in one module
Refer to Circuit/System Testing
- If DTC is not set
- All OK.