Steering Gear Boot Replacement

WARNING: This page is about a different car, the 2016 Chevrolet Trax and 2016 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Steering Gear Boot

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedures Steering Gear Replacement (N40 With MNK) Steering Gear Replacement (NJ1 With MNH or MNK) Steering Gear Replacement (NJ1 With MR5) Steering Gear Replacement (N40 With M4P) Steering Linkage Outer Tie Rod Replacement
1	Steering Linkage Inner Tie Rod Nut CAUTION: Refer to Fastener Caution . Procedure Place match marks on the steering linkage inner tie rod nut and the steering linkage inner tie rod.
2	Steering Gear Boot Outer Clamp
3	Steering Gear Boot Inner Clamp Procedure Cut the steering gear boot inner clamp. DISCARD the clamp. Use the CH-804 pliers to install a NEW steering gear boot inner clamp. Special Tools CH-804 Boot Clamp Pliers Equivalent regional tools:Special Tools
4	Steering Gear Boot Procedure After removing the steering gear boot, inspect the steering linkage inner tie rod for evidence of corrosion or contamination.If corrosion or contamination is evident, replace the steering gear. Steering Gear Replacement (N40 With MNK) Steering Gear Replacement (NJ1 With MNH or MNK) Steering Gear Replacement (NJ1 With MR5) Steering Gear Replacement (N40 With M4P) Install the steering gear boot and ensure the boot is seated in the assembly groove of the steering gear before installing the steering gear boot clamps.