Component Testing
WARNING: This page is about a different variant/trim than selected.
Dynamic Test
- Install a 10 A fused jumper wire between the control terminal 4 X1 and 12 V. Momentarily install a jumper wire between the ground terminal 2 X1 and ground.
- Verify the solenoid turns on & off/clicks, etc.
- If the solenoid does not turn on & off/clicks, etc.
Replace the S3 transmission shift lever.
- If the solenoid does turn on & off/clicks, etc.
- If the solenoid does not turn on & off/clicks, etc.
- All OK