LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Buick >> 2013 >> Verano Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 194 (Cellular System, Entertainment System, And Navigation System) >> Diagnostic Information and Procedures >> DTC B2455 >> Circuit/System Testing
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Circuit/System Testing

WARNING: This page is about a different car, the 2012 Buick Verano. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, disconnect the harness connector at the B24 cellular phone microphone, ignition ON.
  2. Test for 9.5-10.5 V between the signal+ circuit terminal B and ground.
    • If less than 9.5 V 
    1. Ignition OFF, disconnect the X2 harness connector at the K73 telematics communication interface control module.
    2. Test for infinite resistance between the signal+ circuit and ground.
      • If less than infinite resistance, repair the short to ground in the circuit.
      • If infinite resistance
    3. Test for less than 2 Ω in the signal+ circuit end to end.
      • If 2 Ω or greater, repair the open/high resistance in the circuit.
      • If less than 2 Ω, replace the vehicle K73 telematics communication interface control module.
    • If greater than 10.5 V 
    1. Ignition OFF, disconnect the X2 harness connector at the K73 telematics communication interface control module, ignition ON.
    2. Test for less than 1 V between the signal+ circuit and ground.
      • If 1 V or greater, repair the short to voltage on the circuit.
      • If less than 1 V, replace the K73 telematics communication interface control module.
    • If between 9.5-10.5 V 
  3. Ignition ON.
  4. Test for less than 1 V between the singal- circuit terminal A and ground.
    • If greater than 1 V 
    1. Ignition OFF, disconnect the X2 harness connector at the K73 telematics communication interface control module, ignition ON.
    2. Test for less than 1 V between the signal- circuit and ground.
      • If 1 V or greater, repair the short to voltage in the circuit.
      • If less than 1 V, repair the K73 telematics communication interface control module.
    • If less than 1 V 
  5. Test for 9.5-10.5 V between the signal+ circuit terminal B and the signal- circuit terminal A.
    • If not between 9.5-10.5 V 
    1. Ignition OFF, disconnect the connector X2 at the K73 telematics communication interface control module.
    2. Test for infinite resistance between the signal- circuit and ground.
      • If less than infinite resistance, repair the short to ground in the circuit.
      • If infinite resistance
    3. Test for less than 2 Ω in the signal- circuit end to end.
      • If 2 Ω or greater, repair the open/high resistance in the circuit.
      • If less than 2 Ω, replace the K73 telematics communication interface control module.
    • If between 9.5-10.5 V 
  6. Test or replace the B24 cellular phone microphone.
scientia non olet · About LEMON Manuals