Circuit/System Testing
WARNING: This page is about a different car, the 2012 Buick Verano. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition OFF, disconnect the navigation antenna coax cable connector at the A11 radio. Connect the EL-49903 GM OnStar antenna diagnostic tool kit to the A11 radio, place the test antenna on the roof of the vehicle.
- Ignition ON, radio ON, navigation selected.
- Verify DTC B2462 is not set.
- If DTC B2462 is set
Replace the A11 radio.
- If DTC B2462 is not set
- If DTC B2462 is set
- Ignition OFF, disconnect the radio navigation coax cable at the T15 navigation signal splitter.
- Verify the radio navigation coax cable passes the coax cable component test. Refer to Component Testing below.
- If the coax cable does not pass the test
Replace the coax cable
- If the coax cable passes the test
- If the coax cable does not pass the test
- Test or replace the T15 navigation signal splitter.