DTC P0496: EVAP System High Purge Flow Detected
WARNING: This page is about a different car, the 2011 Honda Insight and 2010 Honda Insight. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information (see
GENERAL TROUBLESHOOTING INFORMATION
).
- Turn the ignition switch to ON (II).
- Clear the DTC with the HDS.
- Do the EVAP FUNCTION TEST in the INSPECTION MENU with the HDS.
Is the result OK?
YES -Intermittent failure, the system is OK at this time. Check for poor connections or loose terminals at the FTP sensor, the EVAP canister purge valve, the EVAP canister vent shut valve, and the PCM.
NO -Go to step 4.
- Turn the ignition switch to LOCK (O).
- Replace the EVAP canister purge valve (see EVAP CANISTER PURGE VALVE REPLACEMENT ).
- Turn the ignition switch to ON (II).
- Reset the PCM with the HDS.
- Do the PCM idle learn procedure (see PCM IDLE LEARN PROCEDURE ).
- Do the EVAP FUNCTION TEST in the INSPECTION MENU with the HDS.
Is the result OK?
YES -Troubleshooting is complete.
NO -Check for poor connections or loose terminals at the FTP sensor, the EVAP canister purge valve, the EVAP canister vent shut valve, and the PCM, then go to step 1.