Reprogram Control Module

WARNING: This page is about a different car, the 2016 Chevrolet Malibu Limited. However, it is still accessible from the selected car via links, so may be relevant.

To reprogram an existing control module, perform the following procedure:

Access the Service Programming System (SPS) and follow the on-screen instructions.
On the SPS Supported Controllers screen, select K43 Power Steering Control Module - Programming and follow the on-screen instructions.
On the SPS Supported Controllers screen, select K43 Power Steering Control Module - Configuration & Setup and follow the on-screen instructions.
At the end of programming, choose the "Clear All DTCs" function on the SPS screen.
With a scan tool, perform the Steering Angle Sensor Centering and Software Endstop Learning procedure. Refer to Power Steering Control Module Calibration .
With a scan tool, Clear all DTCs after completing the calibration procedure.