Installation Procedure
- If replacing the fuel tank transfer parts as necessary.
- With the aid of an assistant, position the fuel tank on a hydraulic lift and raise into vehicle position.
- Install both fuel tank straps (2) to the fuel tank (1) and tighten the fasteners (3) to 27 N.m (20 lb ft).
- Remove the hydraulic lift from the fuel tank.
- Connect the evaporative emission purge and fuel pipes (1). Refer to Plastic Collar Quick Connect Fitting Service .
- Connect the fuel pressure sensor harness connector (2).
- Install the fuel tank filler tube (2) and tighten the clamp (1) to 4 N.m (35 lb in).
- Connect the fuel tank filler vent pipe to the fuel tank vent pipe (3). Refer to Plastic Collar Quick Connect Fitting Service .
- Connect the fuel tank fuel pump module wiring harness (1).
- Install the exhaust system. Refer to Exhaust Muffler Replacement (Single)Exhaust Muffler Replacement (Dual) .
- Install the two front differential mounting bolts. Differential Carrier Assembly Replacement
- Install the propeller shaft. Refer to Propeller Shaft Replacement .
- Refuel the fuel tank.
CAUTION:
Refer to Fastener Caution .