LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Buick >> 2018 >> Enclave Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 38 (Engine Cooling System) >> Specifications >> Fastener Specifications
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Fastener Specifications

WARNING: This page is about a different car, the 2017 GMC Acadia Limited, 2017 Chevrolet Traverse, and 2017 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.
Single Use Non-Threaded Fasteners/Components

NOTE:

All fasteners/components listed in this table MUST BE DISCARDED and replaced with NEW after removal. 

Application
Thermostat Gasket
Water Outlet Housing Seal
Water Pump Seal
Single Use Threaded Fastener/Component Tightening Specifications

NOTE:

All fasteners/components listed in this table MUST BE DISCARDED and replaced with NEW after removal. 

Application Specification
Metric (English)
Water Pump Bolt
  • First Pass:
10 N.m (89 lb in)
  • Second Pass:
10 N.m (89 lb in)
  • Final Pass:
45 Degrees
Reusable Threaded Fastener Tightening Specifications

NOTE:

All fasteners listed in this table can be reused after removal. 

Application Specification
Metric (English)
Coolant Recovery Reservoir Bolt 5 N.m (44 lb in)
Drain Plug 22 N.m (16 lb ft)
Engine Oil Cooler Fitting 24 N.m (18 lb ft)
Fan Shroud Mounting Bolt 10 N.m (89 lb in)
Radiator Mounting Bolt 10 N.m (89 lb in)
Thermostat Housing Bolt 10 N.m (89 lb in)
Thermostat Housing Retainer Bolt 50 N.m (37 lb ft)
Water Outlet Housing Bolt 10 N.m (89 lb in)
Water Pump Pulley Bolt 10 N.m (89 lb in)