Fastener Specifications
WARNING: This page is about a different car, the 2018 Chevrolet Trax and 2018 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
Single Use Threaded Fastener/Component Tightening Specifications
|
NOTE:
All fasteners/components listed in this table MUST BE DISCARDED and replaced with NEW after removal. |
|
|---|---|
| Application | Specification |
| Metric (English) | |
| Front Lower Control Arm Front Bolt | |
|
115 N.m (85 lb ft) |
|
Loosen 720 degrees |
|
80 N.m (59 lb ft) |
|
90 - 105 degrees |
| Front Lower Control Arm Rear Bolt | |
|
80 N.m (59 lb ft) |
|
60 - 75 degrees |
Reusable Threaded Fastener Tightening Specifications
|
NOTE:
All fasteners listed in this table can be reused after removal. |
|
|---|---|
| Application | Specification |
| Metric (English) | |
| Front Lower Control Arm Ball Stud Nut (At Knuckle) | |
|
42 N.m (31 lb ft) |
|
Loosen 120 degrees |
|
35 N.m (26 lb ft) |
|
30 - 45 degrees |
| Front Lower Control Arm Ball Stud Nut | 35 N.m (26 lb ft) |
| Front Stabilizer Shaft Insulator Clamp Nut | 22 N.m (16 lb ft) |
| Front Stabilizer Shaft Link Nut | 65 N.m (48 lb ft) |
| Front Strut Rod Mount Nut | 65 N.m (48 lb ft) |
| Front Suspension Strut Nut | 110 N.m (81 lb ft) |
| Front Suspension Strut Upper Mounting Nut | 65 N.m (48 lb ft) |