Calibrate Control Module
WARNING: This page is about a different car, the 2018 Chevrolet Trax and 2018 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
To calibrate control module, perform the following procedure:
- Install a scan tool.
- Ignition ON.
- Select Rear Differential Clutch Service Calibration Setup in the Rear Differential Clutch Control Module Configuration/Reset Function List.
- Follow the scan tool directions to complete the calibration procedure.
NOTE:
The clutch service calibration will be a single numeric digit. It will be found etched (1) on clutch pack housing. The top of the numeric digit is towards the prop-shaft flange.