Fastener Specifications
WARNING: This page is about a different car, the 2018 Buick Envision. However, it is still accessible from the selected car via links, so may be relevant.
Single Use Non-Threaded Fasteners/Components
|
NOTE:
All fasteners/components listed in this table MUST BE DISCARDED and replaced with NEW after removal. |
|---|
| Application |
| Engine Coolant Thermostat Housing Seal |
| Thermostat Bypass Pipe Gasket |
| Turbocharger Coolant Feed Pipe Gasket |
| Turbocharger Coolant Pipe Copper Washer |
| Water Pump Gasket |
| Water Pump Seal |
Reusable Threaded Fastener Tightening Specifications
|
NOTE:
All fasteners listed in this table can be reused after removal. |
|
|---|---|
| Application | Specification |
| Metric (English) | |
| Engine Coolant Air Bleed Pipe Fastener | 10 N.m (89 lb in) |
| Engine Coolant Auxiliary Fan Shroud Bolt | 9 N.m (80 lb in) |
| Engine Coolant Fan Motor Bolt | 8 N.m (71 lb in) |
| Engine Coolant Thermostat Housing Fastener | 10 N.m (89 lb in) |
| Radiator Air Upper Baffle Bolt | 9 N.m (80 lb in) |
| Radiator Bolt @ Engine Coolant Fan Shroud | 5.1 N.m (45 lb in) |
| Radiator Surge Tank Bolt | 9 N.m (80 lb in) |
| Radiator Upper Mount Bracket Bolt | 12 N.m (106 lb in) |
| Thermostat Bypass Pipe Fasteners | 10 N.m (89 lb in) |
| Turbocharger Coolant Feed Pipe Bolt | 35 N.m (26 lb ft) |
| Turbocharger Coolant Feed Pipe Fastener | 10 N.m (89 lb in) |
| Turbocharger Coolant Return Pipe Bolt | 35 N.m (26 lb ft) |
| Turbocharger Coolant Return Pipe Fastener | 10 N.m (89 lb in) |
| Water Pump Bolt | |
|
25 N.m (18 lb ft) |
|
25 N.m (18 lb ft) |