Fastener Specifications
WARNING: This page is about a different car, the 2018 Buick Envision. However, it is still accessible from the selected car via links, so may be relevant.
Single Use Non-Threaded Fasteners/Components
|
NOTE:
All fasteners/components listed in this table MUST BE DISCARDED and replaced with NEW after removal. |
|---|
| Application |
| Brake Caliper Guide Pin Bushing |
| Brake Hose Fitting Gasket |
| Caliper Piston Dust Boot |
| Caliper Piston Seal |
| Parking Brake Actuator Seal |
Reusable Threaded Fastener Tightening Specifications
|
NOTE:
All fasteners listed in this table can be reused after removal. |
|
|---|---|
| Application | Specification |
| Metric (English) | |
| Brake Caliper Bleeder Valve - Front | 11 N.m (97 lb in) |
| Brake Caliper Bleeder Valve - Rear | 10 N.m (89 lb in) |
| Brake Caliper Bracket Bolt - Front | |
|
150 N.m (111 lb ft) |
|
15-30 Degrees |
| Brake Caliper Bracket Bolt - Rear | |
|
100 N.m (74 lb ft) |
|
15-30 Degrees |
| Brake Caliper Guide Pin Bolt - Front | 47 N.m (35 lb ft) |
| Brake Caliper Guide Pin Bolt - Rear | 25 N.m (18 lb ft) |
| Brake Hose Fitting Bolt - Front and Rear | 40 N.m (30 lb ft) |
| Brake Rotor Bolt - Front and Rear | 9 N.m (80 lb in) |