Replace and Program Control Module

WARNING: This page is about a different car, the 2018 Buick Envision. However, it is still accessible from the selected car via links, so may be relevant.

To program a replacement control module, perform the following procedure:

Access the Service Programming System (SPS) and follow the on-screen instructions.
On the SPS Supported Controllers screen, select K17 Electronic Brake Control Module - Programming and follow the on-screen instructions.
On the SPS Supported Controllers screen, select K17 Electronic Brake Control Module - Setup and Configuration follow the on-screen instructions.
At the end of programming, choose the "Clear All DTCs" function on the SPS screen.
With a scan tool, perform the Electronic Brake Control Module-Control Functions Automated Brake Bleed following the scan tool instructions. Refer to Antilock Brake System Automated Bleed .