Installation Procedure
WARNING: This page is about a different car, the 2020 Buick Regal TourX, 2020 Buick Regal, 2019 Buick Regal TourX, and 2019 Buick Regal. However, it is still accessible from the selected car via links, so may be relevant.
Electronic Brake Control Module (1) - Install
- Nut (2) @ Electronic Brake Control Module - Tighten [2x] 9 N.m (80 lb in)
Remove the caps or plugs from the brake pipe fitting and the brake pressure modulator valve.
- Brake Pressure Modulator Valve Primary Pipe Fitting (1) - Install and tighten 32 N.m (24 lb ft)
Remove the caps or plugs from the brake pipe fitting and the brake pressure modulator valve.
- Brake Pressure Modulator Valve Secondary Pipe Fitting (1) - Install and tighten 32 N.m (24 lb ft)
Remove the caps or plugs from the brake pipe fitting and the brake pressure modulator valve.
- Brake Pipe Fitting-Front-Left Side (1) - Install and tighten 18 N.m (13 lb ft)
Remove the caps or plugs from the brake pipe fitting and the brake pressure modulator valve.
- Brake Pipe Fitting-Rear-Right Side (1) - Install and tighten 18 N.m (13 lb ft)
Remove the caps or plugs from the brake pipe fitting and the brake pressure modulator valve.
- Brake Pipe Fitting-Rear-Left Side (1) - Install and tighten 18 N.m (13 lb ft)
Remove the caps or plugs from the brake pipe fitting and the brake pressure modulator valve.
- Brake Pipe Fitting-Front-Right Side (1) - Install and tighten 18 N.m (13 lb ft)
Electrical Connector (1) @ Electronic Brake Control Module - Disconnect
- Radiator Surge Tank Replacement - Install
- Engine Control Module - Reposition - Engine Control Module Replacement
- Connect the battery negative cable. Battery Negative Cable Disconnection and Connection (2.0L LTG)
- Bleed the brake system. Hydraulic Brake System Bleeding (Pressure) , or Hydraulic Brake System Bleeding (Manual)
- Run all necessary programming and setup procedures. Control Module References
- Center the steering angle sensor. Steering Wheel Angle Sensor Centering
CAUTION: