LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Buick >> 2020 >> Envision Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 42 (Heating System, Ventilation System, And Air Conditioning System) >> Specifications >> Fastener Specifications
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Fastener Specifications

WARNING: This page is about a different car, the 2018 Buick Regal TourX and 2018 Buick Regal. However, it is still accessible from the selected car via links, so may be relevant.
Single Use Non-Threaded Fasteners/Components

NOTE:

All fasteners/components listed in this table MUST BE DISCARDED and replaced with NEW after removal. 

Application
Air Conditioning Compressor Hose Seal
Air Conditioning Compressor and Condenser Hose Seal
Air Conditioning Condenser Hose Seal
Air Conditioning Compressor Oil Filler Plug Seal
Air Conditioning Evaporator Inlet Tube Seal
Air Conditioning Evaporator Outlet Tube Seal
Air Conditioning Evaporator Thermal Expansion Valve Seal
Air Conditioning Receiver and Dehydrator Fitting Seal
Air Conditioning Refrigerant Pressure Sensor Seal
Heater and Air Conditioning Evaporator and Blower Module Seal
Reusable Threaded Fastener Tightening Specifications

NOTE:

All fasteners listed in this table can be reused after removal. 

Application Specification
Metric (English)
Air Conditioning Compressor Bolt 22 N.m (16 lb ft)
Air Conditioning Compressor Bracket Bolt 22 N.m (16 lb ft)
Air Conditioning Compressor Nut 22 N.m (16 lb ft)
Air Conditioning Condenser Nut 19 N.m (14 lb ft)
Air Inlet Housing Bolt 2.5 N.m (22 lb in)
Auxiliary Heater Core Screw 2.5 N.m (22 lb in)
Blower Motor Bolt 2.5 N.m (22 lb in)
Blower Motor Control Module Bolt 2.5 N.m (22 lb in)
Engine Coolant Exhaust Muffler Bolt 9 N.m (80 lb in)
Engine Coolant Heater Bracket Bolt 8 N.m (71 lb in)
Engine Coolant Heater Bracket Nut 9 N.m (80 lb in)
Engine Coolant Heater Control Module Nut 3 N.m (27 lb in)
Engine Coolant Heater Exhaust Muffler Clamp 6 N.m (53 lb in)
Engine Coolant Heater Exhaust Pipe Clamp 6 N.m (53 lb in)
Engine Coolant Heater Fuel Pump Bracket Bolt 6 N.m (53 lb in)
Engine Coolant Heater Pump Bracket Nut 5 N.m (44 lb in)
Floor Front Air Outlet Duct Bolt 1.5 N.m (13 lb in)
Heater and Air Conditioning Evaporator and Blower Upper Case Bolt 2.5 N.m (22 lb in)
Heater and Air Conditioning Evaporator Case Bolt 2.5 N.m (22 lb in)
Heater Coolant Pump Bolt 9 N.m (80 lb in)
Instrument Panel Compartment Air Duct Bolt 1.5 N.m (13 lb in)
Passenger Compartment Air Filter Housing Cover Screw 2.5 N.m (22 lb in)