Common Specs & Procedures Index
COMMON SPECS & PROCEDURES
| SYSTEM | SPECIFICATION/PROCEDURE | ||
|---|---|---|---|
| Air Conditioning | |||
| Service | APPROXIMATE FLUID CAPACITIES |
||
| Torque | FASTENER SPECIFICATIONS | ||
| Wheel Drive Shaft Nut | |||
| Front or Rear | First Pass: 150 N.m (111 lb ft) Second Pass: Loosen 45 degrees Final Pass 250 N.m (185 lb ft) |
||
| Battery | BATTERY INSPECTION/TEST , or BATTERY ELECTRICAL DRAIN/PARASITIC LOAD TEST | ||
| Brakes | |||
| Bleeding Sequence | RIGHT REAR, LEFT FRONT, LEFT REAR, RIGHT FRONT HYDRAULIC BRAKE SYSTEM BLEEDING |
||
| Disc Brakes | |||
| Service Specifications | DISC BRAKE COMPONENT SPECIFICATIONS | ||
| Torque | FASTENER SPECIFICATIONS | ||
| Charging | |||
| Generator | CHARGING SYSTEM TEST | ||
| Torque | FASTENER SPECIFICATIONS | ||
| Drive Belt | |||
| Adjustment | Non-Adjustable Serpentine Belt | ||
| Drive Belt Routing | See the figure under ACCESSORY DRIVE PRIMARY BELT REPLACEMENT | ||
| Engine Cooling | |||
| General Service Specifications | SPECIFICATIONS | ||
| Radiator Cap Pressure | RADIATOR SURGE TANK CAP TESTING | ||
| Thermostat R & I | |||
| ENGINE COOLANT THERMOSTAT HOUSING PIPE REPLACEMENT | |||
| Water Pump R & I | |||
| ELECTRIC ENGINE COOLANT PUMP REPLACEMENT | |||
| Engine Mechanical | |||
| Compression | ENGINE COMPRESSION TEST | ||
| Oil Pressure | @ 1500 RPM 100°C: -199.95 kPa (29 psi) | ||
| Overhaul | ENGINE MECHANICAL SPECIFICATIONS | ||
| Torque | FASTENER SPECIFICATIONS | ||
| Fluid Specifications | See FLUIDS under MAINTENANCE/FLUIDS tab. From within Manager or Service Writer, click the "30/60/90 Interval" or "Maint." button. | ||
| Flex Plate Torque | First Pass: 20 N.m (15 lb ft) Final Pass - 70 degrees |
||
| Fuel System | |||
| Fuel Pressure Test Procedure | CIRCUIT/SYSTEM VERIFICATION | ||
| Fuel Filter Location | Fuel Filter is Part of the Fuel Tank Fuel Pump Module | ||
| Fuel Filter R & I | FUEL TANK FUEL PUMP MODULE REPLACEMENT (AWD) or FUEL TANK FUEL PUMP MODULE REPLACEMENT (FWD) | ||
| Ignition | |||
| Firing Order & Cylinder Identification | FIRING ORDER & CYLINDER IDENTIFICATION | ||
| Ignition Wires (Resistance) | Coil On Plug | ||
| Ignition Wires (Routing) | Coil On Plug | ||
| Spark Plug | |||
| See Parts Catalog for Application | |||
| Gap | 0.70 - 0.80 mm (0.028 - 0.031 in) | ||
| Torque | 17 N.m (13 lb ft) | ||
| Starting | |||
| Starter | STARTER REPLACEMENT | ||
| Torque | FASTENER SPECIFICATIONS | ||
| Wheel Alignment | |||
| Adjustment Specifications | WHEEL ALIGNMENT SPECIFICATIONS | ||
| Torque | FASTENER SPECIFICATIONS | ||
| Wheel & Tire | |||
| Wheel Nut Torque | 190 N.m (140 lb ft) For Tightening Sequence, Please see the Figure Under INSTALLATION PROCEDURE |
||