LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Cadillac >> 1990 >> Allante 440T4/ME9 >> Repair and Diagnosis >> Brakes >> Anti-Lock/Traction Control >> Removal & Installation >> Sensor Block >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Sensor Block: Installation

  1. Pull reed block connector (2-pin) outward to its disengaged position prior to installing sensor block on hydraulic unit.
  2. Thoroughly lubricate the sensor block pressure port O-ring with fresh, clean brake fluid. Carefully insert pressure port into booster/master cylinder assembly orifice, taking care not to cut or damage the O-ring. Position sensor block for installation of mounting bolts.
  3. Install sensor block mounting bolts. Tighten to 35 INCH lbs. (4 N.m).
  4. Engage reed block connector by pressing on Orange connector body marked "PUSH".
  5. Connect valve block connector (12-pin) to sensor block.
  6. Install sensor block cover, gasket and mounting bolt.
  7. Connect sensor block and control pressure switch connectors.
scientia non olet · About LEMON Manuals