Manual Bleeding Procedure

With engine off, remove reserve vacuum by applying brakes several times. Fill master cylinder with brake fluid and keep one-half full during bleeding procedure.
Place proper size box end wrench over bleeder valve. Attach one end of clear tube over valve and submerge other end in container partially filled with clean brake fluid.
Starting at left front wheel, slowly depress brake pedal and hold. Loosen bleeder valve to purge air from cylinder. Tighten bleeder valve and slowly release brake pedal. Repeat sequence until all air is removed.
Remove tube and wrench. Proceed to right front wheel, left rear wheel and finish at right rear wheel. Fill master cylinder and replace cover.