Window Regulator: Removal
- Remove door trim panel. See DOOR TRIM PANEL
. Remove appropriate door module. See DOOR MODULES
. Remove water deflector.
- Remove inside handle assembly (4) to gain access to window clamp attachment bolts:
- Carefully pry front of assembly (4) rearward.
- Pull front of assembly (4) outward.
- Slide assembly (4) rearward to remove. See Figure
or Figure
.
- Disconnect handle rod (3) from clip guide (2). See Figure
.
- Connect power window switch and door module. Raise window to full up position. Tape window in place.
- Loosen window clamp attachment fasteners. Lower regulator clamps (2) to full down position. See Figure
.
- Disconnect electrical connector from window regulator motor.
- Remove window regulator to inner door panel fasteners (2, 3). Remove window regulator (1) from inner door panel. See Figure
.