Using Scan Tool

NOTE: Procedure is written specifically for use with GM Tech I or Tech II scan tools. Generic scan tool can be used but may have limited functions.

NOTE: This procedure is used to program both memory seats and power mirrors.

Connect scan tool to Data Link Connector (DLC). DLC is located below left side of instrument panel, near steering column.
Turn ignition switch to RUN position.
Select correct vehicle and model year.
Select body.
Select personalization.
Select set options.
Select Driver #1 memory recall or Driver #2 memory recall.
Select one of these options: auto exit driver seat, key in IGN recall driver seat, remote entry recall driver seat, recall exit on RKE unlock.
Press ENTER to turn option on or off. (An asterisk appears next to current options).
Exit from menu.
Select Driver #1 auto exit seat or Driver #2 auto exit seat.
Highlight auto exit seat and press ENTER button to turn selection on or off. (An asterisk appears next to feature turned on.).
Exit from menu.