Installation Procedure
- Install the air compressor (2) to the vehicle.
- Slide the air compressor forward to secure the fasteners into the frame slots and tighten the mounting nuts.
Tighten: Tighten the nuts to 15 N.m (11 lb ft).
- Install the air inlet hose (1) to the fuel filler neck bracket.
- Connect the air tube (1) to the air dryer.
- Connect the electrical connection (2).
- Lower the vehicle.
NOTE:
Refer to Fastener Notice in Cautions and Notices.
IMPORTANT:
Before driving the vehicle, turn the ignition on and wait approximately 45 seconds. This will ensure that the air adjustable shock absorbers are filled with residual pressure.