LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Cadillac >> 2003 >> Escalade EXT >> Repair and Diagnosis >> External Pages >> Different car >> Section 455 (Entertainment System) >> Repair Instructions >> Amplifier Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2004 GMC Yukon XL, 2004 GMC Yukon, 2004 Chevrolet Tahoe, 2004 Chevrolet Suburban, and 2004 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  1. Install the audio amplifier to the floor console lower bracket.
  2. Install the amplifier screws.

    Tighten:  Tighten the screws to 3.4 N.m (30 lb in).

    3. Fig 1: Installing Audio Amplifier Screws
    GM882649Courtesy of GENERAL MOTORS CORP.
  3. Install the floor console.
  4. Connect the floor console electrical connector.
  5. Install the screws (1) that retaining the upper console bracket to the lower console bracket.

    Tighten:  Tighten the retaining screws to 2 N.m (18 lb in).

    6. Fig 2: Installing Screws Retaining Upper Console Bracket
    GM1207763Courtesy of GENERAL MOTORS CORP.
  6. Install the bolts (1) retaining the console to the I/P.

    Tighten:  Tighten the bolts to 4 N.m (35 lb in).

    7. Fig 3: Installing Bolts Retaining Console To I/P
    GM1207835Courtesy of GENERAL MOTORS CORP.
  7. Install both front console side panel screws (1).

    Tighten:  Tighten the screws to 2 N.m (18 lb in).

    8. Fig 4: Locating Console Side Panel Screw
    GM1207752Courtesy of GENERAL MOTORS CORP.
  8. Move both front seats to the fully forward.
  9. Install both rear console side panel screws (2).

    Tighten:  Tighten the retaining screws to 2 N.m (18 lb in).

  10. Reposition the inboard seat track trim (1).
    11. Fig 5: View Of Seat Track Trim & Rear Console Side Panel Screw
    GM1207757Courtesy of GENERAL MOTORS CORP.
  11. Connect the audio amplifier electrical connectors.
  12. Connect the floor console electrical connector.
  13. Install the center console end panel. Refer to Center Console End Panel Replacement in Instrument Panel, Gages and Console.
  14. Install the console storage bin. Refer to Console Storage Bin Replacement (Expect Pro) in Instrument Panel, Gages and Console.
  15. Install the cupholder to the console. Refer to Cupholder Replacement (Non-Luxury) , Cupholder Replacement (Luxury) , Cupholder Replacement (Rear) or Cupholder Replacement (Platinum) in Instrument Panel, Gages and Console.
  16. Install the upper console bezel. Refer to Bezel Replacement - Floor Console (Non-Luxury Upper) or Bezel Replacement - Floor Console (Luxury Upper) in Instrument Panel, Gages and Console.
  17. Install the radio amp fuse. Refer to Electrical Center Identification Views in Wiring Systems.
  18. If the amplifier has been replaced, perform the audio amplifier set up procedure for the BOSE™ amplifier with UQ7 and Y91. Refer to Audio Amplifier Setup .
scientia non olet · About LEMON Manuals