Installation Procedure

WARNING: This page is about a different car, the 2004 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Removing & Installing Data Link Connector

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the screws securing the data link connector to the I/P carrier.
Tighten: Tighten the screws to 2 N.m (18 lb in).
Install the I/P closeout panel. Refer to Closeout/Insulator Panel Replacement - Left .