Scan Tool Data Definitions

WARNING: This page is about a different car, the 2004 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.

Battery Voltage: The scan tool displays 0-30 Volts. The voltage measured between the module's battery positive voltage circuit and ground circuit.
Driver Door Jamb Sw.: The scan tool displays On/Off. Display indicates the state of the drivers door jamb switch. On indicates the door is open and Off indicates the door is closed.
Ignition 1: The scan tool displays Active/Inactive. The scan tool displays Active when the Ignition 1 input circuit of the RIM receives a battery voltage signal from the IGN-1 RELAY.
Ignition 1 Run/Crank: The scan tool displays Active/Inactive. The scan tool displays Active when the Run/Crank circuit of the DIM receives a battery voltage signal from the ignition switch.
Ign. Accessory/Run: The scan tool displays Active/Inactive. The scan tool displays Active when only the Accessory/Run circuits of the DIM receives a battery voltage signal from the ignition switch.
Ignition Switch: The scan tool displays Accy/Crank/Off/RAP/Run. The scan tool displays Accy when the accessory and unlock circuits of the DIM receives a battery voltage signal from the ignition switch. The scan tool displays Crank when the Crank/Run, Run and Unlock circuits of the DIM receives a battery voltage signal from the ignition switch. The scan tool displays Off when none of the power moding circuits of the DIM receive a battery voltage signal from the ignition switch. The scan tool displays RAP (Retained Accessory Power) when RAP is active and none of the power moding circuits of the DIM receive a battery voltage signal from the ignition switch. The scan tool displays Run when all of the power moding circuits of the DIM receive a battery voltage signal from the ignition switch.
Left Rear Door Jamb Sw.: The scan tool displays On/Off. Display indicates the state of the left rear door jamb switch. On indicates the door is open and Off indicates the door is closed.
Pass. Door Jamb Sw.: The scan tool displays On/Off. Display indicates the state of the right front door jamb switch. On indicates the door is open and Off indicates the door is closed.
Power Mode Change: The scan tool displays when the vehicles power source has changed to ON, IGN, or RAP and CTD is activated.
RAP Output: The scan tool displays On/Off. Display indicates the status of the RAP function.
Rt. Rear Door Jamb Sw.: The scan tool displays On/Off - Display indicates the state of the right rear door jamb switch. On indicates the door is open and Off indicates the door is closed.