Crankshaft Position Sensor: Service and Repair

Crankshaft Position (CKP) Sensor Replacement
REMOVAL PROCEDURE

IMPORTANT: Perform the CKP System Variation Learn Procedure whenever the crankshaft position sensor is removed or replaced.







1. Remove the starter.
2. Disconnect the crankshaft position (CKP) sensor electrical connector.

Crankshaft Position Sensor (CKP):

3. Clean the area around the CKP sensor before removal in order to avoid debris from entering the engine.
4. Remove the CKP sensor bolt.
5. Remove the CKP sensor.

Crankshaft Position Sensor (CKP):

INSTALLATION PROCEDURE
1. Install the CKP sensor.

NOTE: Refer to Fastener Notice in Service Precautions Fastener Notice.

2. Install the CKP sensor bolt.

Tighten
Tighten the bolt to .................................25 N.m (18 lb ft).




3. Connect the CKP sensor electrical connector.
4. Install the starter.
5. Perform the CKP system variation learn procedure. Programming and Relearning