LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Cadillac >> 2004 >> XLR >> Repair and Diagnosis >> Steering >> Steering Wheel And Steering Column >> Repair Instructions >> Steering Wheel Control Switch Assembly Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

  1. Install the wire harness to the steering wheel control switch assembly.
    2. Fig 1: Identifying Engagement Tabs For Steering Wheel Control Switch Assembly
    GM803005Courtesy of GENERAL MOTORS CORP.
  2. Align the steering control switch assembly engagement tabs to the steering wheel.

    Push in on the steering wheel control switch assembly in order to secure the control switch assembly to the steering wheel.

    3. Fig 2: Identifying Steering Control Switch Retaining Screws
    GM803006Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the steering wheel control harness retainer and screw.

    Tighten:  Tighten the screw to 2.3 N.m (20 lb in).

  4. Install the steering wheel control switch assembly screws.

    Tighten:  Tighten the screws to 2.3 N.m (20 lb in).

    5. Fig 3: Steering Wheel Control Switch Assembly
    GM754855Courtesy of GENERAL MOTORS CORP.
  5. Connect the steering wheel control electrical connector.
  6. Secure the connector to the retaining clip.
  7. Install the steering wheel inflatable restraint module. Refer to Inflatable Restraint Steering Wheel Module Replacement in SIR.
  8. Enable the SIR. Refer to SIR Disabling and Enabling Zone 3 in SIR.
scientia non olet · About LEMON Manuals