LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Cadillac >> 2005 >> Escalade EXT >> Repair and Diagnosis >> Steering >> Electronic Steering >> Rear Wheel Steering System >> Repair Instructions >> Rear Position Sensor Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

    Fig 1: View Of Rear Wheel Position Sensor, Retaining Bolts, O-Ring & Cover
    GM745262Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Make sure the O-ring (1) is installed.
  1. Install the rear wheel position sensor (2) to the steering gear.
    2. IMPORTANT: Be careful to maintain the position of the replacement sensor.
  2. Remove the pin retaining the position of the new sensor and immediately install the sensor to the steering gear.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the rear wheel position sensor retaining bolts. Apply LOCTITE 242 blue.

    Tighten:  Tighten the bolts to 4 N.m (35 lb in).

  4. Install the rear wheel position sensor cover (4).
    5. Fig 2: View Of Rear Position Sensor Electrical Connector
    GM747768Courtesy of GENERAL MOTORS CORP.
  5. Connect the electrical connector (1).
    6. Fig 3: View Of Steering Gear Protection Shield, Retaining Bolts & Drain Plug
    GM742182Courtesy of GENERAL MOTORS CORP.
  6. Install the steering gear protection shield (1) and retaining bolts (3).

    Tighten:  Tighten the steering gear protection shield retaining bolts to 180 N.m (132 lb ft).

  7. Lower the vehicle.
  8. Perform a four wheel alignment. Refer to Measuring Wheel Alignment (w/Rear Wheel Steering) or Measuring Wheel Alignment (w/o Rear Wheel Steering) in Wheel Alignment.
scientia non olet · About LEMON Manuals