Navigation Module: Service and Repair

NAVIGATION DATA PROCESSOR REPLACEMENT

REMOVAL PROCEDURE
1. Remove the left rear body side trim panel.




2. Remove the nuts (1) securing the processor to the vehicle.




3. Disconnect the electrical connectors (1,2)
4. Remove the processor.

INSTALLATION PROCEDURE




1. Connect the electrical connectors (1,2)




2. Locate the processor the vehicle.
3. Install the nuts (1) securing the processor to the vehicle.

Tighten the nuts to 9 N.m (80 lb in).

NOTE: Refer to Fastener Notice in Service Precautions.

4. Install the left rear body side trim panel.