Driver 1/Driver 2: Notes

The numbers on the back of each keyless access transmitter correspond to DRIVER 1 and DRIVER 2. If you would like to recall or store driver settings for the driver that does not correspond to the number on the back of the keyless access transmitter that you are using, use the following procedure:

1. Enter the memory programming mode for your driver settings by following the instructions listed previously under "Entering the Driver Selection Submenu."
2. From the DRIVER SELECTION submenu, turn the tune/select knob to highlight the driver number that you want, either DRIVER 1 or DRIVER 2.
3. Set your choice by pressing in the tune/select knob.

If you would like to recall driver settings for the selected driver, see "RECALL DRIVER SETTINGS" later in this section.

If you would like to store driver settings for the selected driver, see "STORE DRIVER SETTINGS" later in this section.

If you would like to recall exit settings for the selected driver, see "RECALL EXIT SETTINGS" later in this section.

If you would like to store exit settings for the selected driver, see "STORE EXIT SETTINGS" later in this section.