Fuel Tank Pressure Sensor: Service and Repair

FUEL TANK PRESSURE SENSOR REPLACEMENT

REMOVAL PROCEDURE




- Raise and support the vehicle. Refer to Vehicle Lifting.
- Disconnect the fuel tank pressure sensor electrical connector (1).




- Remove the fuel tank pressure sensor from the evaporative emission (EVAP) canister.

IMPORTANT: There are alignment features on the canister, however, there are no locking tabs on the sensor/canister. The sensor is held into the canister by the tight fit of the multi-lip seal.

INSTALLATION PROCEDURE




- Install the fuel tank pressure sensor to the EVAP canister until fully seated.

IMPORTANT: There are alignment features on the canister, however, there are no locking tabs on the sensor/canister. The sensor is held into the canister by the tight fit of the multi-lip seal.




- Connect the fuel tank pressure sensor electrical connector (1).
- Lower the vehicle.