LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Cadillac >> 2005 >> STS V6-3.6L VIN 7 >> Repair and Diagnosis >> Powertrain Management >> Computers and Control Systems >> Knock Sensor >> Service and Repair >> Knock Sensor (KS) 1 Replacement
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Knock Sensor (KS) 1 Replacement



KNOCK SENSOR (KS) REPLACEMENT - BANK 1

REMOVAL PROCEDURE




- Turn the ignition OFF.
- Raise and support the vehicle. Refer to Vehicle Lifting.
- Reposition the wiring harness heat shield to obtain access.
- Remove the knock sensor (KS) electrical connector.




- Remove the KS bolt.
- Remove the KS.

INSTALLATION PROCEDURE




- Install the KS.
- Install the KS bolt.

NOTE Refer to Fastener Notice in Service Precautions.

Tighten the KS bolt to 23 N.m (17 lb ft).




- Install the KS electrical connector.
- Install the wiring harness heat shield to the original position.
- Lower the vehicle.
scientia non olet · About LEMON Manuals