Removal Procedure

IMPORTANT: When removing the power window switch, place the ignition switch in the OFF position.

Remove the door trim panel. Refer to Trim Panel Replacement - Door .
Remove the retainer screws from the back of the upper trim panel.
Remove the upper trim from the door.

Fig 1: View Of Door Panel Inner Energy Absorber

Courtesy of GENERAL MOTORS CORP.

Remove the inner energy absorber from the door panel.
Remove 4 retaining screws from the rear of the armrest.
Remove 1 retaining screw from the forward end of the armrest assembly.

Fig 2: View Of Armrest Assembly & Screws

Courtesy of GENERAL MOTORS CORP.

Disconnect the armrest wire harness and remove the armrest assembly.

Fig 3: View Of Front Door Switch Assembly

Courtesy of GENERAL MOTORS CORP.

IMPORTANT: Use care when removing the power window switch assembly, because the mirror, the window, and the applique to the door lock switch plate can be easily damaged. Apply duct tape to protect the finish.

Remove the power window switch assembly from the pocket in the door trim panel.
Disconnect the wire harness to the power window switch.

Fig 4: View Of Door Switch Assemblies & Door Switch Bezel

Courtesy of GENERAL MOTORS CORP.

Remove the power window switch from the armrest switch plate applique.