LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Cadillac >> 2006 >> DTS 4.6 9 >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Collision/Avoidance >> Object Detection System >> Repair Instructions >> Front Object Alarm Sensor Replacement >> Removal Procedure
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Removal Procedure

    Fig 1: View Of Rear Object Sensor Electrical Connectors
    GM489061Courtesy of GENERAL MOTORS CORP.
  1. Remove front bumper fascia. Refer to Fascia Replacement - Front Bumper in Bumpers.
  2. Disconnect electrical from the front object sensor.
    3. Fig 2: View Of Rear Object Sensor Assembly
    GM500502Courtesy of GENERAL MOTORS CORP.
  3. Lift the locking tabs on the housing (4) and remove the front object sensor (1).
    4. Fig 3: View Of Spring & Housing
    GM489063Courtesy of GENERAL MOTORS CORP.
  4. Squeeze the spring (1) and remove it from the housing (2).
    5. Fig 4: View Of Rear Object Sensor Housing
    GM489064Courtesy of GENERAL MOTORS CORP.
  5. Release the tabs on the housing and remove.
    6. Fig 5: Painting Rear Object Sensor Bezel
    GM489066Courtesy of GENERAL MOTORS CORP.
  6. Remove the front object sensor bezel by pushing it through the fascia.
scientia non olet · About LEMON Manuals