Circuit/System Verification
- If DTCs P0641 or P0651 are set, refer to Diagnostic Trouble Code (DTC) List - Vehicle for further diagnosis.
- With the ignition ON and the engine OFF, observe that the AIR pressure sensor parameter is nearly identical to the MAP sensor parameter.
- With the engine running, observe and record the AIR Pressure Sensor voltage parameter. With the engine running enable the AIR pump relay with a scan tool and observe that the AIR Pressure Sensor voltage parameter increases more than 0.4 volts during AIR pump operation.
- With the engine running, enable the AIR pump relay with a scan tool and observe that the AIR Pressure Sensor parameter equals approximately 10-15 kPa above BARO.