Circuit/System Testing For DTC P0171
- Allow the engine to reach operating temperature. With the engine running, observe the Long Term FT parameter with a scan tool. The value should be less than approximately 24 percent with the engine running at operating temperature.
- If the value is more than 24 percent, inspect for the following:
- With the ignition ON and the engine OFF, observe the manifold absolute pressure (MAP) sensor parameter. The MAP sensor pressure should be within the range specified for your altitude. Refer to Altitude Versus Barometric Pressure
.
- Vacuum hoses for splits, kinks, and proper connections
- Insufficient fuel in the tank
- A malfunctioning MAF-Refer to DTC P0068 or P0121 or DTC P0101 .
- Low fuel pressure
- Fuel contamination
- Improperly functioning fuel injectors
- Missing, loose, or leaking exhaust components from the HO2S forward
- Vacuum leaks at the intake manifold, the throttle body, and the injector O-rings
- The air induction system and the air intake ducts for leaks or for a missing air filter element
- Evaporative canister purge lines plugged or obstructed
- Damage to the EVAP canister
- The crankcase ventilation system for leaks
- The HO2S for proper installation and for electrical wires or connectors that may have contacted the exhaust system
- The HO2S signal circuit open, shorted to ground, or shorted to the low reference circuit
- The HO2S sensor 1 low signal circuit for an open circuit or high resistance
- Malfunctioning engine components