Power Door Lock Switch Replacement

Power Door Lock Switch Replacement

Removal Procedure




1. Remove the inside handle bezel from the inner door panel in the following order:

1. Hold the inside handle (1) to the open position.
2. Insert a flat-bladed tool at the front lower corner of the bezel.
3. Pry outward on the bezel.
4. Remove the bezel from the inner door panel.

2. Disconnect the electrical connector from the lock switch.

Installation Procedure

1. Snap the door lock switch into the door switch bezel.
2. Connect the electrical connector.
3. Slide the bezel over the door handle.




4. Snap the bezel into position by pushing on lower front corner of bezel.