Circuit/System Verification
- If any other AIR DTCs are set, perform those diagnostics first.
- Engine running, observe that the AIR Pressure Sensor parameter approximately equals BARO.
- Engine running, enable the AIR pump relay with a scan tool and observe that the AIR Pressure Sensor parameter equals approximately 10-20 kPa above barometric pressure (BARO).
- Engine running, enable the AIR system with a scan tool and observe that the AIR Pressure Sensor parameter equals approximately 8-10 kPa above BARO.
- Engine running, observe the DTC information with a scan tool. DTC P0411 should not set.
- Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.