Circuit/System Verification
- If DTCs P0411, P0418, P0641, P0651, P2432 or P2433 are set then perform those diagnostics first.
- Ignition ON, observe that the AIR pump is not activated.
- If the AIR pump is operating, test the AIR pump voltage supply circuit for a short to voltage. If the circuit tests normal, test the AIR pump relay control circuit for a short to ground. If the circuits test normal, test the AIR pump relay. If the relay and circuits test normal, replace the control module.
- Ignition ON, enable and disable the AIR pump relay with a scan tool, listen for the AIR pump to turn ON and OFF.
- Engine running, observe the DTC information with a scan tool. DTC P2444 should not set.
- Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.