LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Cadillac >> 2007 >> Escalade EXT >> Repair and Diagnosis >> Body & Frame >> Ignition Switch/Steering Lock >> Wiring Systems And Power Management - Introduction >> Repair Instructions >> Ignition Lock Cylinder Replacement >> Removal Procedure
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Removal Procedure

  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
    2. CAUTION: Refer to SIR Caution .
  2. Disable the SIR system. Refer to SIR Disabling and Enabling .
  3. Lower the hush and knee bolster. Refer to Knee Bolster Replacement (Cadillac) or Knee Bolster Replacement (Except Cadillac) .
  4. Remove the steering column trim covers. Refer to Steering Column Trim Covers Replacement .
  5. With the key installed, turn the key to the START position.
    6. Fig 1: View Of Lock Cylinder & Allen Wrench
    GM1413814Courtesy of GENERAL MOTORS CORP.
  6. Install an allen wrench into the hole on top of the lock cylinder housing.

    Push down on the allen wrench to release the tab on the lock cylinder inside the lock cylinder housing.

    7. Fig 2: View Of Lock Cylinder At Lock Cylinder Housing
    GM1413837Courtesy of GENERAL MOTORS CORP.
  7. Slide the lock cylinder out of the lock cylinder housing.
scientia non olet · About LEMON Manuals