Circuit/System Description

WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.

Pressing the NAV button, located on the Infotainment Faceplate Control Module or faceplate, sends a 5-volt signal on the popup position control circuit to the Display Module Actuator. The 5-volt signal sets the position of the Display Module Actuator commanding the display to the Up position. Pressing the NAV button again removes the signal on the circuit commanding the display to the Down position.

When the display is commanded to the Up position, the motor controller, located in the actuator, sends a 5-volt signal on the popup position sense circuit to the navigation radio. The circuit is a hard wired input from the motor controller to the radio. This signal is read by the radio in order to know which graphics to render on the touch-screen display.