Installation Procedure

WARNING: This page is about a different car, the 2006 GMC Sierra, 2006 GMC Cab & Chassis Sierra, 2006 Chevrolet Silverado, and 2006 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Fig 1: Installing Audio Amplifier To Floor Console Lower Bracket

Courtesy of GENERAL MOTORS CORP.

Install the audio amplifier to the floor console lower bracket.
Install the amplifier screws.
Tighten: Tighten the screws to 3.4 N.m (30 lb in).
Install the floor console.
Connect the floor console electrical connector.
Install the screws (1) that retaining the upper console bracket to the lower console bracket.

Fig 2: Installing Screws Retaining Upper Console Bracket To Lower Console Bracket
Courtesy of GENERAL MOTORS CORP.

Tighten: Tighten the retaining screws to 2 N.m (18 lb in).
Install the bolts (1) retaining the console to the I/P.

Fig 3: Installing Bolts Retaining Console To I/P
Courtesy of GENERAL MOTORS CORP.

Tighten: Tighten the bolts to 4 N.m (35 lb in).
Install both front console side panel screws (1).

Fig 4: Locating Console Side Panel Screw
Courtesy of GENERAL MOTORS CORP.

Tighten: Tighten the screws to 2 N.m (18 lb in).
Move both front seats to the fully forward.
Install both rear console side panel screws (2).

Fig 5: View Of Seat Track Trim & Rear Console Side Panel Screw
Courtesy of GENERAL MOTORS CORP.

Tighten: Tighten the retaining screws to 2 N.m (18 lb in).
Reposition the inboard seat track trim (1).
Connect the audio amplifier electrical connectors.
Connect the floor console electrical connector.
Install the center console end panel. Refer to Center Console End Panel Replacement in Instrument Panel, Gages and Console.
Install the console storage bin. Refer to Console Storage Bin Replacement (Expect Pro) or Console Storage Bin Replacement (Pro) in Instrument Panel, Gages and Console.
Install the cupholder to the console. Refer to Cupholder Replacement (Luxury) or Cupholder Replacement (Non-Luxury) or Cupholder Replacement (Rear) or Cupholder Replacement (Pro) in Instrument Panel, Gages and Console.
Install the upper console bezel. Refer to Bezel Replacement - Floor Console (Non-Luxury Upper) or Bezel Replacement - Floor Console (Luxury Upper) or Bezel Replacement - Floor Console (Non-Luxury Lower) in Instrument Panel, Gages and Console.
Install the radio amp fuse. Refer to Electrical Center Identification Views in Wiring Systems.
If the amplifier has been replaced, perform the audio amplifier set up procedure for the BOSE™ amplifier with UQ7 and Y91. Refer to Audio Amplifier Setup .