LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Cadillac >> 2007 >> Escalade EXT >> Repair and Diagnosis >> External Pages >> Different car >> Section 708 (Antilock Brake System With Traction Control System) >> Repair Instructions >> Electronic Brake Control Module Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2006 GMC Sierra, 2006 GMC Cab & Chassis Sierra, 2006 Chevrolet Silverado, and 2006 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    IMPORTANT:
    • Do not reuse the old mounting screws. Always install new mounting screws with the new EBCM.
    • Do not use RTV or any other type of sealant on the EBCM gasket or mating surfaces.
    Fig 1: Installing EBCM
    GM925878Courtesy of GENERAL MOTORS CORP.
  1. Install the EBCM to the BPMV.
    2. NOTE: Refer to Fastener Notice .
    Fig 2: Exploded View Of EBCM & BPMV Components
    GM925574Courtesy of GENERAL MOTORS CORP.
  2. Install the new EBCM screws (1).

    Tighten:  Tighten the screws to 5 N.m (39 lb in) in an X-pattern.

  3. Lower the vehicle.
  4. Connect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure (Single Battery) or Battery Negative Cable Disconnect/Connect Procedure (Auxiliary Battery) .
  5. If a new EBCM was installed, the EBCM must be programmed. Refer to Service Programming System (SPS) .
  6. Turn the ignition to the ON position. DO NOT start the engine.
  7. Perform the Diagnostic System Check - Vehicle .
scientia non olet · About LEMON Manuals