LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Cadillac >> 2007 >> Escalade EXT >> Repair and Diagnosis >> External Pages >> Different car >> Section 708 (Antilock Brake System With Traction Control System) >> Repair Instructions >> Electronic Brake Control Module Replacement >> Removal Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal Procedure

WARNING: This page is about a different car, the 2006 GMC Sierra, 2006 GMC Cab & Chassis Sierra, 2006 Chevrolet Silverado, and 2006 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Refer to BATTERY DISCONNECT CAUTION .
IMPORTANT: After installation, calibrate the new electronic brake control module (EBCM) to the tire size that is appropriate to the vehicle.
  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure (Single Battery) or Battery Negative Cable Disconnect/Connect Procedure (Auxiliary Battery) .
  2. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle .
    3. IMPORTANT: The area around the electric hydraulic control unit (EHCU) MUST be free from loose dirt to prevent contamination of disassembled ABS components.
  3. Thoroughly wash all contaminants from around the EHCU.
  4. Remove the mounting screws (1) that fasten the EBCM (2) to the brake pressure modulator valve (BPMV) (3).
    Fig 1: Exploded View Of EBCM & BPMV Components
    GM925574Courtesy of GENERAL MOTORS CORP.
  5. Remove the EBCM from the BPMV. Removal may require a light amount of force.
    Fig 2: Removing EBCM
    GM925878Courtesy of GENERAL MOTORS CORP.
  6. Remove the EBCM from the vehicle.
  7. Clean the BPMV to EBCM mounting surfaces with a clean cloth.
scientia non olet · About LEMON Manuals