LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Cadillac >> 2007 >> Escalade EXT >> Repair and Diagnosis >> External Pages >> Different car >> Section 796 (Supplemental Inflatable Restraint System) >> Repair Instructions >> Inflatable Restraint Steering Wheel Module Coil Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    IMPORTANT: A new roll connector is equipped with a yellow tab that is removed after the steering wheel is installed. This tab passes through the steering wheel.
  1. Route the SIR wiring harness and horn/cruise connector down steering column.
  2. Fig 1: Removing & Installing Inflatable Restraint Steering Wheel Module Roll Connector
    GM890633Courtesy of GENERAL MOTORS CORP.
  3. Snap the SIR coil into position on the column.
  4. Connect the SIR coil and horn/cruise electrical connectors.
  5. Attach the wiring harness clips to the bracket below the column.
  6. Install the steering column covers. Refer to Steering Column Trim Covers Replacement .
  7. Install the steering wheel. Refer to Steering Wheel Replacement .
  8. Install the inflatable restraint steering wheel module. Refer to Inflatable Restraint Steering Wheel Module Replacement .
  9. Enable the SIR system. Refer to SIR Disabling and Enabling .